RB700 jumpers

Table 1 presents the conventions used for the ON and OFF jumper settings.

Table 1. ON/OFF jumpers conventions

CONVENTION DEFINITION
ON Jumper fitted
OFF Jumper not fitted
1-2 Jumper fitted between Pin 1 and Pin 2

The table below presents a description of the RB700 jumpers.

Table 2. RB700 jumpers

NAME DESCRIPTION DEFAULT
JP1 CM4 EEPROM_nWP signal control
ON – EEPROM memory write protection enabled
OFF – EEPROM memory write protection disabled
OFF
JP3 RS-485 port 1 termination resistor
ON – termination resistor connected
OFF – termination resistor disconnected
ON
JP4 RS-485 port 2 termination resistor
ON – termination resistor connected
OFF – termination resistor disconnected
ON
JP5 CM4 nRPI_BOOT signal control
1-2 – nRPI_BOOT enabled when USB device cable is connected
2-3 – nRPI_BOOT enabled
OFF – nRPI_BOOT disabled
1-2